46
Exit Without Saving
When you do not want to save the changes you have made, highlight
this option and press <Enter>. The message below will appear:
Quit Without Saving (Y/N)? N
Type “Y” and press <Enter>. The system will reboot and you will once
again see the initial diagnostics on the screen. If you wish to make any
changes to the setup, press <Ctrl> <Alt> <Esc> simultaneously or
<Del> after memory testing is done.
System Error Report
When the BIOS encounters an error that requires the user to correct
something, either a beep code will sound or a message will be dis-
played in a box in the middle of the screen and a message PRESS F1
TO CONTINUE, CTRL-ALT-ESC or DEL TO ENTER SETUP will be
shown in the information box at the bottom.
POST Beep
There is one beep code in BIOS. This code indicates that a video error
has occurred and the BIOS cannot initialize the video screen to display
any additional information. This beep code consists of a single long
beep followed by two short beeps.
Error Messages
One or more of the following messages may be displayed if the BIOS
detects an error during the POST.
DISK BOOT FAILURE, INSERT SYSTEM DISK AND PRESS ENTER
No boot device was found. Insert a system disk into Drive A and press
<Enter>. If the system normally boots from the hard drive, make sure
the controller is inserted correctly and all cables are properly attached.
Also be sure the disk is formatted as a boot device. Then reboot the
system.
