50
2
Hardware Installation
The system board supports the chassis intrusion detection function.
Connect the chassis intrusion sensor cable from the chassis to the J3
connector. Whenever a chassis component has been removed, the
sensor sends signal to J3 alerting you of a chassis intrusion event. To
disable this function, place a jumper cap over J3.
Winbond HW Doctor
Install the “Winbond HW Doctor” utility. By default, the chassis
intrusion detection function is disabled. When enabled, a warning
message will appear when the chassis is open. The utility can also be
configured so that a beeping alarm will sound when the chassis is
open. Refer to the “Winbond HW Doctor” section in chapter 4 for
more information.
2.6.9 Chassis Open Connector
X
1
2
Ground
Chassis
signal
