
www.dfi .com
Chapter 3 Hardware Installation
13
Chapter 3
Installing the DIMM Module
1. Make sure the PC and all other peripheral devices connected to it has been powered down.
2. Disconnect all power cords and cables.
3. Locate the SODIMM socket on the system board.
4. Note the key on the socket. The key ensures the module can be plugged into the socket in
only one direction.
6. Push down the module until the clips at each end of the socket lock into position. You will
hear a distinctive “click”, indicating the module is correctly locked into position.
Clip
5. Grasping the module by its edges, align the module into the socket at an approximately 30
degrees angle. Apply firm even pressure to each end of the module until it slips down into
the socket. The contact fingers on the edge of the module will almost completely disappear
inside the socket.
Clip
Note:
The system board used in the following illustrations may not resemble the actual
board. These illustrations are for reference only.
Summary of Contents for CM960-B
Page 1: ...www dfi com Chapter 1 Introduction 1 CM960 B COM Express Basic Module User s Manual A32100420...
Page 62: ...www dfi com Chapter 5 Supported Software 62 Chapter 5 WatchDog DIO Backlight...
Page 76: ...www dfi com 76 Appendix E Appendix E BIOS Status Code PEI Beep Codes DXE Status Codes...
Page 77: ...www dfi com 77 Appendix E Appendix E BIOS Status Code...