
www.dfi .com
Chapter 3 Hardware Installation
12
Chapter 3
System Memory
DDR3_2
Standby
Power LED
The system board is equipped with two 204-pin SODIMM sockets that support DDR3 up to
16GB system memory.
DDR3_1
Important:
Electrostatic discharge (ESD) can damage your board, processor, disk drives, add-in
boards, and other components. Perform installation procedures at an ESD workstation
only. If such a station is not available, you can provide some ESD protection by wear-
ing an antistatic wrist strap and attaching it to a metal part of the system chassis. If
a wrist strap is unavailable, establish and maintain contact with the system chassis
throughout any procedures requiring ESD protection.
Important:
When the Standby Power LED lit red, it indicates that there is power on the system
board. Power-off the PC then unplug the power cord prior to installing any devices.
Failure to do so will cause severe damage to the motherboard and components.
Summary of Contents for CM960-B
Page 1: ...www dfi com Chapter 1 Introduction 1 CM960 B COM Express Basic Module User s Manual A32100420...
Page 62: ...www dfi com Chapter 5 Supported Software 62 Chapter 5 WatchDog DIO Backlight...
Page 76: ...www dfi com 76 Appendix E Appendix E BIOS Status Code PEI Beep Codes DXE Status Codes...
Page 77: ...www dfi com 77 Appendix E Appendix E BIOS Status Code...