45
2
Hardware Installation
The system board supports the chassis intrusion detection function.
To use this function, connect the chassis intrusion sensor cable from
the chassis to J1. Whenever a chassis component has been removed,
the sensor sends signal to J1 alerting you of a chassis intrusion
event. To disable this function, place a jumper cap over J1.
Winbond Hardware Doctor Utility Setting
Install “Winbond Hardware Doctor Utility” contained in the provided
CD. By default, this function is disabled. When enabled, a warning
message will appear when the chassis is open. The utility can also be
configured so that a beeping alarm will sound when the chassis is
open. Refer to the “Winbond Hardware Doctor Utility” section in
chapter 4 for more information.
2.7.11 Chassis Open Alarm Connector
1
2
Ground
Chassis
signal
