PROGRAMMING INSTRUCTIONS:
Programming can be accomplished manually using the machine controls or by connecting to the
machine control using a PDA (personal digital assistant). For instructions on using a PDA with
this washer control, please contact your local Dexter distributor. Please read below for manual
programming instructions.
The washer has two levels of programming. The Coin/Price Programming allows the owner to
set the price for the washer features and the values of the coins. The Washer Cycle Programming
allows the owner complete access to the wash cycle parameters – add/remove a bath, bath times,
spin times, water temperatures, etc. To enter the programming modes, the top of the washer must
be unlocked and slid toward the back of the washer a few inches.
COIN PRICE PROGRAMMING
While the washer is in the Idle mode, push the Programming pushbutton on the controller. The
Idle mode is when the washer is not running a cycle and the price of the bath is displayed. The
Programming pushbutton is a very small buttoned located on the upper center of the controller
directly behind the display. There are six stages in the Coin/Price Programming mode.
To step through to the desired stage, repeatedly push the right-hand Warm temperature
button until the desired stage is blinking on the display. To exit the Coin/Price
programming mode, push and hold the Cold temperature button for 5 seconds.
Stage 1: Right Coin – The display will blink first a “r” indicating right coin and then a coin value
($1.00 – default). The display will blink back and forth between the “r” and the value. To
change the value, use the Hot temperature button to decrease and the left-hand Warm
temperature button to increase. The value will change in 5
¢
steps. The range of values is from
$00.00 to $99.95. When the desired right coin value is displayed, push the right-hand Warm
temperature button once to store the new value and a second time to move to the next Coin/Price
programming step.
To exit the Coin/Price programming mode, push the Cold temperature button for 5 seconds.
Stage 2: Left Coin – The display will blink first a “L” indicating left coin and then a coin value
($0.25– default). The display will blink back and forth between the “L” and the value. To
change the value, use the Hot temperature button to decrease and the left-hand Warm
temperature button to increase. The value will change in 5
¢
steps. The range of values is from
$00.00 to $99.95. When the desired left coin value is displayed, push the right-hand Warm
temperature button once to store the new value and a second time to move to the next Coin/Price
programming step. To exit the Coin/Price programming mode, push the Cold temperature button
for 5 seconds.
Stage 3: Wash Price – The display will blink first a “P” indicating wash price and then present
wash price. The display will blink back and forth between the “P” and the price. To change the
value, use the Hot temperature button to decrease and the left-hand Warm temperature button to
increase. The value will change in 5
¢
steps. The range of values is from $00.05 to $99.95.
When the desired price is displayed, push the right-hand Warm temperature button once to store
the new value and a second time to move to the next Coin/Price programming step. To exit the
