Delay Fill “dF”
The selections are “d” for delay the bath time until water
level is reached or “t” for decrement bath time during the
fill.
Spin Time “S”
0 to 10 minutes for Prewash, Wash, Rinse1 and Rinse2
1 to 10 minutes for Final Spin.
“IS”
The owner can change the displayed value, but for a coin
washer only 0 will be put into the cycle.
COIN WASHER DEFAULT CYCLE
The following table shows the complete details for the coin washer default cycle.
Bath
Bath Cycle
Time
(min.)
Water
Temp.
Water
Level *
Delay Fill
Spin Time
(min.)
IS *
Prewash
0
Wash
9
CH
LO
t
0
Rinse 1
4
CC
LO
t
1
0
Rinse 2
0
Final
Rinse
5
CC
LO
t
4
0
Note *
These default values are preset and cannot be changed.
Rapid Advance Mode
To enter the Rapid Advance mode, push and hold the Cold water temperature button and then
push the programming button on the controller. There will be no observed change to the washer
or the display. The Rapid Advance mode can be entered from either the Idle mode or during the
cycle. To rapid advance to the next step in the wash cycle, push both warm temperature buttons
at the same time. The display will show an “Ad” (advance) in the display. The washer will
advance to the next bath segment. The water will drain before the advance will occur.
The Rapid Advance mode will not end until the final bath segment is completed. The final
segment cannot be skipped in Rapid Advance mode.
Notes: 1. When the Rapid Advance mode is used, the cycle time will no longer be correct.
2. By skipping steps with rapid advance, the door may not open immediately at the end
of the cycle.
