Dexter Laundry 3276007357349, Instruction Manual

Page: 124 / 148

124
If the cooling water pipe gets brittle, blocked or is damaged it can easily be replaced by another pipe of
the same type. Release the connections and the holders. Mount a new pipe with the same length. Fix it
(just like the old one).
LUBRICATING
From time to time the guiding rails and the bearings of the motor need to be lubricated.
rst undo the clamping screws and push
them, together with the machine head to the same side as the transport wheels, then fasten the two
clamping screws again.
• Fold up the feet one after the other, ideally starting on the same side as the transport wheels so as not
to overload the transport handle when putting the equipment down.
• The equipment can now be transported using the transport handle.
• The equipment can be parked in minimum space as shown. When parking, put your foot on the axle
to prevent the equipment from rolling away.
TRANSPORT
rst undo the clamping screws and push
them, together with the machine head to the same side as the transport wheels, then fasten the two
clamping screws again.
• Fold up the feet one after the other, ideally starting on the same side as the transport wheels so as not
to overload the transport handle when putting the equipment down.
• The equipment can now be transported using the transport handle.
• The equipment can be parked in minimum space as shown. When parking, put your foot on the axle
to prevent the equipment from rolling away.
STORAGE
Store the equipment and its accessories out of the reach of children in a dark, dry place at above
freezing temperature.
The ideal storage temperature is between 5 and 30° C. Store the electric tool in its original packaging.
Regularly, depending on conditions of use
What
Check all screwed connections and tighten them
if necessary
How?
Visual inspection.
Clean dust and splinters from the machine. Blow dust and splinters away with compresses air,
or use a brush.
Remove all dust and splinters from the Ventilation
slits of the motor. Romove the dust and splinters with a vacuum
cleaner or a brush.
Change the cooling water. Let the cooling water out of the water container,
clear water.
If necessary
What
Changing the cutting wheel.
How?
Refer to the section “CHANGING THE DIAMOND
CUTTING WHEEL”.
Cooling water pipe is damaged. Replace the cooling water pipe. (See below)
Remove deposits from the cold water pump. Wipe the deposits away with a cloth.
FR
ES
PT
IT
EL
PL
UA
RO
EN