shield or ground to the RF antenna of the mouse and receiver. Operating on a metal
surface may shorten the transmission distance.
If your notebook computer has a metal (contains Al or Mg) case, the metal housing
of the LCD panel will isolate partial radiation of the RF signal from the mouse. This could
possibly result in reducing the distance of transmission when you operate the mouse
right in front of the notebook and when the receiver is connected on the back of the
notebook. However, the RF mouse should work properly while you are operating the
mouse just beside your desktop computer.
Battery Warning!
When replace the batteries, use alkaline. You may use rechargeable NiMH or
other type of batteries, but do not mix then with alkaline. Do not mix used and new
batteries together!
BEFORE YOU BEGIN
Keep this installation guide for future reference! It contains Important
Troubleshooting Information.
Keep your old PS/2 mouse as a back-up device.
HARDWARE INSTALLATION
Inserting the Batteries
The wireless keyboard uses 2 AAA batteries. They are inserted as follows:
1. Turn the keyboard over to show the underside.
2. Release the battery cover.
3. There are signs to indicate positive and negative orientation for the batteries.
Take care to insert the batteries correctly.
