background image

Operation

Switching the alarm on and off

The mini personal alarm is ready for immediate operation. 

o

  Pull out the pin 

W

 - and the alarm will sound. 

o

  Push the pin 

W

 in again - the alarm will switch off. 

The alarm will sound as long as the pin is left out, until the battery is 
exhausted.

Switching the light on and off

o

    Press the button 

I

 to switch on the light 

O

. The light will shine 

for as long as you keep the button pressed. 

Attaching the belt clip

o

   Screw the fixing screw 

R

 clockwise approx. 2 mm into the hous-

ing back 

{

.

o

   Push the belt clip 

T

 over the head of the fixing screw.

o

   Now tighten the fixing screw into the housing back.

Attaching the key ring

o

  Insert the fixing screw 

R

 through the eye at the end of the chain 

U

.

o

   Screw the fixing screw clockwise tightly into the housing back 

{

.

Note: 

If you do not wish to attach either the belt clip or the keyring, 

screw the fixing screw into the housing back so as to prevent moisture 
and dirt from getting into the alarm.

Changing the battery

From time to time you should check the charge state of the battery by 
briefly pulling out the pin. If the alarm sounds weak you should replace 
the battery as follows:

o

   Insert the pin 

W

 into the alarm.

o

   Open the alarm 

Q

 by removing the two housing screws 

P

 from 

the housing back 

{

 using a small crosshead screwdriver and tak-

ing off the battery compartment lid.

o

  Carefully take out the battery 

}

, e.g. with the aid of a pencil.

o

    Insert a new battery. Observe the correct polarity. 

 

 Position the positive pole (+) of the battery to correspond with the 
positive marking (+) on the battery compartment.

o

   Screw the battery compartment lid back on to the alarm.

Rectifying faults

Fault

Cause

Remedy

The alarm does not 
sound even though 
the pin has been 
pulled out.

-    The battery is  

exhausted.

-    The battery has 

been inserted the 
wrong way round 
(polarity).

-   Insert a new  

battery.

-    Check that the 

battery has been 
inserted with the 
correct polarity.

The alarm sounds 
but only weakly.

The battery is  
exhausted.

Insert a new battery.

KOE29_T22_GB_IE.indd   3

05.10.2006   11:59:44 Uhr

Reviews: