English
3
3� Insert the battery connector in accordance with the markings for the
batteries (2�4V NiMH 500mAh) inside the handset battery compartment�
4� Replace the battery cover� Align the cover flat against the battery
compartment, then slide it towards the center of the handset until it
clicks into place�
5� Place the handset into the base unit with the keypad facing outwards to
charge� The charge light is on when charging�
Note!
The power adapter is the disconnect device between the product and
wall power. The wall socket outlet must be close to the equipment and
easily accessible.
Battery
When the batteries are relatively new (less than 6 months) and fully-charged (10 hours) they
will last for approx 100 hours standby time or approx 10 hours call time� Full battery capacity
will not be reached until the batteries have been charged 4–5 times� It is not possible to
overcharge or damage the batteries by charging them for ”too long”�
Warning!
Risk of explosion if battery is replaced by an incorrect type� Use only original
type of batteries� The guarantee does not cover any damage caused by using the
wrong batteries�
Note!
When the battery is low or when there is too great a distance to the base unit the
telephone will be unable to connect to a line. Do not place the base unit close to other
electrical equipment, in direct sunlight or other strong heat sources! This is to minimize
the risk of any interference. It is normal for the device to become warm during charging
and this is not dangerous. Dispose of used batteries according to the instructions.