Cleaning the filter pad
Requirements
`
TORX T10 screw driver
WARNING
!
Do not attempt to remove filter covering plate when in operation.
Power off the instrument and disconnect the device from the power supply first.
Any voltage over 50 V connected to the modules must also be terminated.
Procedure
1.
Switch-off the instrument and disconnect any high-voltage sensors/connectors.
2.
Loosen 6 screws of the fan cover plate at the right side of the system using a TORX T10 screwdriver.
3.
Grab the carrying handle and remove the covering plate.
4.
Remove the filter pads.
5.
Clean the filterpads with a dry velocity stream of air.
6.
Reinsert the cleaned filter pads and gently tap them.
maintenance and Service
40