SyStem SetuP
19
DEWE2-M7s • Technical reference • Printing version 1.0.1 • April 8, 2021
Installing a TRION module
1
3
2
5
4
5
Fig. 5:
Installing a TRION module (symbolic image)
1.
DEWE2 chassis
2.
TRION series module
3.
Injector/ejector module
4.
Module guides
5.
Mounting screws
In order to install a TRION module into a chassis proceed as follows:
1.
Take proper ESD precautions to avoid any damage to the unit.
2.
Power off and unplug all connected cables including sensors from the DEWE2 chassis and TRION series modules.
3.
Identify a supported TRION peripheral slot.
Some modules require a TRION STAR-slot. For more information refer to chapter „STAR-slot for TRION modules“
4.
Remove the filler panel of an unused TRION peripheral or STAR-slot.
5.
Place the module edges of the TRION modules into the module guides at the top and bottom of the chassis.
6.
Insert the TRION module to the rear of the chassis until a resistance appears.
7.
Pull up on the injector/ejector handle to latch the device.
8.
Secure the installed TRION front panel to the chassis by using the mounting screws.
The TRION module is now installed into a DEWE2 chassis.
NOTICE
Unused TRION slots must always be covered. Make sure to reinstall the filler panels to unused TRION
slots to guarantee proper cooling of the installed modules.
The warranty is void if the modules overheat due to missing filler panels.