6
•
Pull by the plug rather than the cord when disconnecting the charger.
This will
reduce the risk of damage to the electric plug and cord.
•
Make sure that the cord is located so that it will not be stepped on, tripped
over or otherwise subjected to damage or stress.
•
Do not use an extension cord unless it is absolutely necessary.
Use
of improper extension cord could result in risk of fire, electric shock or
electrocution.
•
When operating a charger outdoors, always provide a dry location and use an
extension cord suitable for outdoor use.
Use of a cord suitable for outdoor use
reduces the risk of electric shock.
•
Do not place any object on top of the charger or place the charger on a soft
surface that might block the ventilation slots and result in excessive internal
heat.
Place the charger in a position away from any heat source. The charger is
ventilated through slots in the top and the bottom of the housing.
•
Do not operate the charger with a damaged cord or plug.
•
Do not operate the charger if it has received a sharp blow, been dropped or
otherwise damaged in any way.
Take it to an authorized service center.
•
Do not disassemble the charger; take it to an authorized service center when
service or repair is required.
Incorrect reassembly may result in a risk of electric
shock, electrocution or fire.
•
Disconnect the charger from the outlet before attempting any cleaning. This
will reduce the risk of electric shock.
Removing the battery pack will not reduce
this risk.
•
NEVER
attempt to connect 2 chargers together.
•
The charger is designed to operate on standard 230 V household electrical
power. Do not attempt to use it on any other voltage.
This does not apply to the
vehicular charger.
Chargers
Your tool uses a D
E
WALT charger. Be sure to read all safety instructions before using
your charger. Consult the chart at the end of this manual for compatibility of chargers
and battery packs.
Charging Procedure (Fig. 1)
1. Plug the charger into an appropriate outlet before inserting the battery pack.
2. Insert the battery pack (F) into the charger, as shown in Figure 1, making sure
the pack is fully seated in charger. The red (charging) light will blink continuously,
indicating that the charging process has started.
3. The completion of charge will be indicated by the red light remaining ON
continuously. The pack is fully charged and may be used at this time or left in the
charger.
FIG. 1
F
Indicator Light Operation
PACK CHARGING
PACK CHARGED
x
HOT/COLD DELAY
PROBLEM PACK OR CHARGER
PROBLEM POWERLINE
Summary of Contents for XR LI-ION DCS320-XE
Page 1: ...DCS320 XE DCS380 XE CORDLESS RECIPROCATING SAWS INSTRUCTION MANUAL ...
Page 2: ......
Page 15: ......
