12
FIG. 13
METAL CUTTING (FIG. 13)
Your saw has different metal cutting capacities depending upon type of blade used
and the metal to be cut. Use a finer blade for ferrous metals and a coarse blade for
non-ferrous materials. In thin gauge sheet metals it is best to clamp wood to both
sides of sheet. This will insure a clean cut without excess vibration or tearing of metal.
Always remember not to force cutting blade as this reduces blade life and causes
costly blade breakage.
NOTE:
It is generally recommended that when cutting metals you should spread a thin
film of oil or other lubricant along the line ahead of the saw cut for easier operation and
longer blade life.
MAINTENANCE
WARNING: To reduce the risk of serious personal injury, place the forward/
reverse button in the lock-off position or turn tool off and disconnect battery pack
before making any adjustments or removing/installing attachments or accessories.
Lubrication
Your power tool requires no additional lubrication.
Cleaning
WARNING:
Blow dirt and dust out of all air vents with clean, dry air at least once
a week. To minimize the risk of eye injury, always wear AS/NZS1337 approved eye
protection when performing this.
WARNING:
Never use solvents or other harsh chemicals for cleaning the
non-metallic parts of the tool. These chemicals may weaken the plastic materials
used in these parts. Use a cloth dampened only with water and mild soap. Never let
any liquid get inside the tool; never immerse any part of the tool into a liquid.
CHARGER CLEANING INSTRUCTIONS
WARNING:
Shock hazard. Disconnect the charger from the AC outlet before
cleaning. Dirt and grease may be removed from the exterior of the charger using a
cloth or soft non-metallic brush. Do not use water or any cleaning solutions.
Repairs
The charger and battery pack are not serviceable. There are no serviceable parts
inside the charger or battery pack.
To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment
(including brush inspection and replacement) should be performed by certified
service centers or other qualified service organizations, always using identical
replacement parts.
ACCESSORIES
WARNING:
Since accessories, other than those offered by D
E
WALT, have not been
tested with this product, use of such accessories with this tool could be hazardous.
To reduce the risk of injury, only D
E
WALT, recommended accessories should be used
with this product.
Recommended accessories for use with your tool are available at extra cost from
your local service center. If you need any assistance in locating any accessory, please
contact Stanley Black & Decker, 82 Taryn Drive, Epping, VIC 3076 Australia or call
1800 444 224 or (NZ). 0800 339 258.
Summary of Contents for XR LI-ION DCS320-XE
Page 1: ...DCS320 XE DCS380 XE CORDLESS RECIPROCATING SAWS INSTRUCTION MANUAL ...
Page 2: ......
Page 15: ......
