DeWalt XR Li-ION DCN690-XE, Instruction Manual

Page: 18 / 28

16
COLD WEATHER OPERATION
When operating tools at temperatures below freezing:
1. Keep tool as warm as possible prior to use.
2. Actuate the tool 10 or 15 times into scrap lumber before using.
HOT WEATHER OPERATION
Tool should operate normally. However, keep tool out of direct sunlight as excessive
heat can deteriorate bumpers and other rubber parts resulting in increased
maintenance.
Rotating Rafter Hook (Fig. 14)
WARNING: Remove nails from magazine before making any adjustments or
servicing this tool. Failure to do so may result in
serious injury.
CAUTION: When not in use, place tool on
its side on a stable surface where it will not
cause a tripping or falling hazard.
CAUTION: Some tools with large battery
packs will stand upright on the battery pack
but may be easily knocked over.
The D
E
WALT cordless nailer includes a rotating
rafter hook (J) and can be easily positioned
to the left or right of the tool to accommodate
left- or right-handed users.
If use of the hook is not desired at all, it can
be rotated to the front or back of the handle
base.
MAINTENANCE
WARNING: To reduce the risk of serious personal injury, lock tool off and
disconnect tool from power source before making any adjustments or removing/
installing attachments or accessories. An accidental start-up can cause injury.
J
FIG. 14
Daily Maintenance Chart
ACTION Clean magazine, pusher, and contact trip mechanism.
WHY Permits smooth operation of magazine, reduces wear, and prevents
jams.
HOW Blowing off the tool with compressed air is the most effective way to
clean the tool. The use of oils, lubricants periodically or solvents is not
recommended as they tend to attract debris and/or damage the plastic
parts of the tool.
ACTION Before each use, check to ensure all screws and fasteners are tight and
undamaged.
WHY Prevents jams and premature failure of tool parts.
HOW Tighten loose screws using the appropriate hex wrench or screwdriver.
Lubrication
NOTICE: NEVER spray or in any other way apply lubricants or cleaning solvents inside
the tool. This can seriously affect the life and performance of the tool.
D
E
WALT tools are properly lubricated at the factory and are ready for use. However, it
is recommended that, once a year, you take or send the tool to a certified service center
for a thorough cleaning and inspection.
Your power tool requires no additional lubrication.
Cleaning
WARNING: Blow dirt and dust out of all air vents with clean, dry air at least once
a week. To minimize the risk of eye injury, always wear AS/NZS1337 approved eye
protection when performing this.
WARNING: Never use solvents or other harsh chemicals for cleaning the
non-metallic parts of the tool. These chemicals may weaken the plastic materials
used in these parts. Use a cloth dampened only with water and mild soap. Never let
any liquid get inside the tool; never immerse any part of the tool into a liquid.