14
OPERATION
WARNING:
To reduce the risk of serious personal injury, turn tool off and
remove the battery pack before making any adjustments or removing/installing
attachments or accessories.
An accidental start-up can cause injury.
Installing and Removing the Battery Pack (Fig. 6)
NOTE:
For best results, make sure your battery pack is fully charged.
FIG. 6
O
J
To install the battery pack (J) into the tool handle, align the battery pack with the rails
inside the tool’s handle and slide it into the handle until the battery pack is firmly
seated in the tool and ensure that it does not disengage.
To remove the battery pack from the tool, press the release button (O) and firmly pull
the battery pack out of the tool handle. Insert it into the charger as described in the
charger section of this manual.
FUEL GAUGE BATTERY PACKS (FIG. 7)
Some D
E
WALT battery packs include a fuel gauge
which consists of three green LED lights that indicate
the level of charge remaining in the battery pack.
To actuate the fuel gauge, press and hold the fuel
gauge button (P). A combination of the three green
LED lights will illuminate designating the level of
charge left. When the level of charge in the battery
is below the usable limit, the fuel gauge will not
illuminate and the battery will need to be recharged.
P
FIG. 7
NOTE:
The fuel gauge is only an indication of the charge left on the battery pack.
It does not indicate tool functionality and is subject to variation based on product
components, temperature and end-user application.
For more information regarding fuel gauge battery packs, please call 1800 444 224
(Aust) or 0800 339 258 (NZ).
Switch
LOCK-OFF BUTTON AND
TRIGGER SWITCH
Your cut-off tool is equipped with
a lock-off button (B).
To lock the trigger switch (A),
press the lock-off button as
shown in Figure 8. When the
lock-off button is depressed to
the lock icon, the unit is locked.
Always lock the trigger switch
when carrying or storing the
tool to eliminate unintentional
starting.
To unlock the trigger switch, press the lock-off button. When the lock-off button is
depressed to the unlock icon, the unit is unlocked. The lock-off button is colored
red
to indicate when the switch is in its
unlocked
position.
Pull the trigger switch (A) to turn the motor ON. Releasing the trigger switch turns the
motor OFF.
NOTE:
This tool has no provision to lock the switch in the ON position, and should
never be locked ON by any other means.
WARNING:
Hold the side handle and body of the tool firmly to maintain control of
the tool at start up and during use and until the wheel or accessory stops rotating.
Make sure the wheel has come to a complete stop be fore laying the tool down.
WARNING:
Allow the tool to reach full speed before touching tool to the work
surface. Lift the tool from the work surface before turning the tool off.
B
UNLOCKED
LOCKED
A
FIG. 8
Summary of Contents for XR Li-Ion DCG412-XE
Page 1: ...DCG412 XE DCG422 XE 18 V CORDLESS CUT OFF TOOL INSTRUCTION MANUAL ...
Page 2: ......
Page 23: ......
