English
14
Fig. O
Cutting a Recess in Concrete Pipe (Fig. P)
WARNING:
Before making any cuts, make sure the
pipe is properly secured on a non-slip surface.
Several cuts are needed to make a recess cut in
concrete pipe and it is important to make the cuts in the
proper sequence.
1. First make two cuts along the length of the pipe.
Always make an axial cut to avoid pinching of the
cutting wheel.
2. Insert wedges into the cuts.
3. Make the third and fourth cuts to complete the recess.
4. If the severed part remains after all four cuts are made,
do not make any more cuts. Break the severed part out.
1
2
3
4
Fig. P
Applications
WARNING:
NEVER cut magnesium with this
tool. Magnesium particles may ignite causing
personal injury.
• 1/8" (3 mm) max. gauge sheet metal
• Concrete, cinder blocks and bricks
• Roofing tiles (terracotta or similar)
• Curb stone/pavers
• Asphalt
• Reinforcing rod; generally under 1" (25.4 mm) diameter
• 1/8" (3 mm) diameter concrete wire mesh
• Corrugated floor and ceiling form (concrete forms)
• Electrical conduit 1/8" (3 mm) wall thickness
• 1/8" (3 mm) max. thick structural forms such as channel,
angles, plate, etc.
nOTE:
The cutting of materials heavier than those listed
above are not recommended due to the possibility of
tool damage.
MAINTENANCE
WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories.
Make sure
the trigger switch is in the OFF position. An accidental
start-up can cause injury.
Maintenance Schedule
Before use
Daily/After work
Clean machine
X
Check/clean handles
X
Check intake port
X
Check battery
X
Check battery compartment
X
Check water intake
X
Check cutting wheel
X
Check guide plate
X
Cleaning
WARNING:
Blow dirt and dust out of all air vents with
clean, dry air at least once a week. To minimize the risk
of eye injury, always wear ANSI Z87.1 approved eye
protection when performing this.
WARNING:
Never use solvents or other harsh
chemicals for cleaning the non-metallic parts of
the tool. These chemicals may weaken the plastic
materials used in these parts. Use a cloth dampened
only with water and mild soap. Never let any liquid
get inside the tool; never immerse any part of the tool
into a liquid.
WARNING:
Do not use pressurized water to
clean your machine. This may damage parts of
the machine.
Accessories
WARNING:
Since accessories, other than those
offered by
D
e
WALT
, have not been tested with this
product, use of such accessories with this tool could be
hazardous. To reduce the risk of injury, only
D
e
WALT
recommended accessories should be used with
this product.
WARNING:
Accessories must be rated for at least
the speed recom mended on the tool warning label.
Wheels and other accessories running over rated
speed can fly apart and cause injury. Accessory
ratings must always be above tool speed as shown on
tool nameplate.
