10
ENGLISH
OPERATING INSTRUCTIONS
PROPER HAND POSITION
Proper hand position requires one hand
on the main handle
C
as shown.
WARNING
: To reduce the risk of serious
personal injury, Always use proper hand
position as shown.
WARNING
: To reduce the risk of serious
personal injury, always hold securely in
anticipation of a sudden reaction.
OPERATING INSTRUCTIONS
INSERT SOCKET ACCESSORY
The insert socket accessory fits into the
large socket on the angle impact wrench.
• To install the socket, insert the socket and
press firmly on the end of the socket until
the socket clicks in place the socket is
firmly seated in the tool.
• To remove the socket, push the release button on the side
D
of the large socket.
Remove the socket and release the button.
WARNING
: To reduce the risk of serious personal injury, place the forward/reverse
button in the lock-off position or turn tool off and disconnect battery pack before
making any adjustments or removing/installing attachments or accessories. An
accidental start-up can cause injury.
WARNING
: Use only impact-rated accessories. Non impact-rated accessories may
break and cause a hazardous condition. Inspect accessories prior to use to ensure
that it con tains no cracks.
CAUTION
: Ensure fastener and/or system will withstand the level of torque generated
by the tool. Excessive torque may cause breakage and possible personal injury.
1
. Place the accessory on the fastener head. Keep the tool pointed straight at the fastener.
2
. Press switch to start operation. Release switch to stop operation. Always check
torque with a torque wrench, as the fastening torque is affected by many factors
including the following:
•
Voltage
: Low voltage, due to a nearly discharged battery, will reduce fastening
torque.
•
Accessory size
: Failure to use the correct accessory size will cause a reduction in
fastening
torque.
•
Bolt size
: Larger bolt diameters generally require higher fastening torque.
Fastening torque will also vary according to length, grade, and torque coefficient.
•
Bolt condition
: Ensure that all threads are free of rust and other debris to allow
proper fastening torque.
VARIABLE SPEED TRIGGER SWITCH
To turn the tool on, squeeze the trigger switch
A
.
To turn the tool off, release the trigger switch.
Your tool is equipped with a brake. The tool will
stop when the trigger switch is fully released. The
variable speed switch enables you to select the best
speed for a particular application. The more you
squeeze the trigger, the faster the tool will operate.
For maximum tool life, use variable speed only for starting holes or fasteners.
NOTE
: Continuous use in variable speed range is not recommended. It may damage
the switch and should be avoided.
FORWARD/REVERSE BUTTON
A forward/reverse control button
B
determines the direction of the tool and also
serves as a lock-off button:
• To select forward rotation, release the trigger switch and depress the forward/
reverse control button on the right side of the tool.
• To select reverse, release the trigger switch and depress the forward/reverse control
button on the left side of the tool.
• The center position of the control button locks the tool in the off position. When
changing the position of the control button, be sure the trigger is released.
NOTE
: The first time the tool is run after changing the direction of rotation, you may
hear a click on start up. This is normal and does not indicate a problem.
A
B
C
D
