English
14
TROUBLESHOOTING
Problem
Possible Cause
Troubleshooting steps
Motor does not run.
Switch is not in On (I) position.
Ensure three position switch is in On (I) position.
Low battery voltage/poor battery connection.
Ensure battery is fully charged and fully inserted.
Tank is full of liquid and sense circuit is tripped.
1. Turn the three position switch to the Off (0) position and
remove battery.
2. Empty tank.
Dust extractor stops running.
Thermal overload has been tripped.
1. Turn the dust extractor off and remove battery.
2. Empty the tank, if needed.
3. Allow the dust extractor to cool.
4. Resinsert the battery and press the three position switch to
the On (I) position to test.
5. If dust extractor will not restart, call 1-800-4D
e
WALT
(1-800-433-9258).
Tank is full of liquid and sense circuit is tripped. 1. Turn the three position switch to the Off (0) position and
remove battery.
2. Empty tank.
Battery is discharged.
Insert fully charged battery.
Battery is not fully inserted.
Remove and reinsert battery.
Dust comes out of unit while using.
Filters not installed properly.
Remove and reinstall per proper procedure.
Filters are damaged/torn.
Replace filters.
Filter gaskets are damaged.
Contact D
e
WALT service center.
Head not installed properly to tank.
Remove, reinstall and ensure latches are fully engaged.
Head gasket damaged.
Contact D
e
WALT service center.
Dust extractor stops capturing dust.
Filters clogged.
Remove filters, tap clean and reinstall.
Filters at end of service life.
Replace with new filters.
Automatic filter cleaning no longer functional.
If filter cleaning system is not heard every 20 seconds, contact
D
e
WALT service center.
Tank full.
Turn unit off and empty tank.
Hose is clogged.
Inspect and clear hose if clog is found.
Hose is not fully connected to tank.
Reinsert and ensure hose latch is fully engaged.
Hose is damaged.
Inspect hose for holes or tears. Replace if damage is found.
Dust extractor is not turned on by
Wireless Tool Control™ equipped
power tool or remote.
Dust extractor is not in Wireless Tool
Control™ ( ) mode.
Move three position switch to Wireless Tool Control™ ( )
mode. Confirm LED is illuminated. If LED is not illuminated
with the 3-position switch in Wireless Tool Control™ ( )
mode, contact D
e
WALT service center.
Remote/power tool is not paired to
dust extractor.
Follow pairing steps.
Remote/power tool is out of range of
dust extractor.
Move dust extractor closer to remote/power tool.
Wireless Tool Control™ remote coin cell is dead. Replace coin cell and retry.
Paired tool's battery is dead.
Ensure paired tool's battery is fully charged and fully inserted.
Low battery voltage/poor battery connection.
Ensure battery is fully charged and fully inserted.
Tank is full of liquid and sense circuit is tripped.
1. Turn the three position switch to the Off (0) position and
remove battery.
2. Empty tank.
Tool does not pair
Dust extractor is not in Wireless Tool
Control™ ( ) mode.
Move three position switch to Wireless Tool Control™ ( )
mode. Confirm LED is illuminated. If LED is not illuminated
with the 3-position switch in Wireless Tool Control™ ( )
mode, contact D
e
WALT service center.
Tool is not Wireless Tool Control™ enabled.
Confirm that tool is Wireless Tool Control™ enabled.
