10
DXST4500
A
SSEMBL
Y
•
Note: There are two (2) Safety Straps with Weld Nuts and
three (3) Shelf Support Straps for every set of crossbeams.
STEP 1
•
Starting with the lowest set of crossbeams, place a Safety
Strap with Weld Nut between the lower ridges of the
crossbeams where two sets of holes have been pre-drilled.
Thread a Safety Strap Bolt up through the bottom of the
pre-drilled holes and through the Weld Nuts, and fully
tighten with the included hex key or drill bit. Repeat for the
second strap on this set of crossbeams, and continue for
the last four straps.
STEP 2
•
Place a Shelf Support Strap perpendicular to the
crossbeams, and insert each end into the slots on each
ridge of the crossbeam. Repeat for the remaining eight
straps.
SHELF SUPPORT AND SAFETY STRAP INSTRUCTIONS
Summary of Contents for DXST4500
Page 2: ......
