DeWalt DXF2035, Original Instructions Manual

Page: 8 / 36

Simple assembly is
Screwdriver or Suitable Drill Equipped with #2 Phillips
Bit.
7. Tools Required (Not Included):
#2 Phillips
8.
Fan Cradle Assembly:
required to use this fan.
8
English
4.
Turning Fan On:
Place fan on stable level surface.
Plug fan into properly grounded outlet. To start the
fan,turn the switch from the OFF position to the
desired fan speed.
5.
Turning Fan Off:
To turn the fan off, turn the
switch from the current fan speed setting to the off
position. Remove plug from outlet.
6. Adjusting Fan Tilt: Loosen the adjustment knob
until the drum rotates freely on the frame. Adjust the
fan to desired tilt angle and re-tighten the knob. Do
not overtighten adjustment knob.
Protecting the environment
Separate collection. Products and batteries
marked with this symbol must not be
disposed of with normal household waste.
Products and batteries contain materials that can be
recovered or recycled reducing the demand for raw
materials. Please recycle electrical products and
batteries according to local provisions. Further
information is available at www.2helpU.com
Optional Accessories
WARNING:
Since accessories, other than those
offered by D
E
WALT, have not been tested with this
product, use of such accessories with this appliance
could be hazardous.
To reduce the risk of injury, only D
E
WALT recommended
accessories should be used with this product.
TROUBLESHOOTING
WARNING:
TO REDUCE THE RISK OF INJURY FROM
MOVING PARTS AND/OR ELECTRICAL SHOCK,
TURN POWER SWITCH OFF AND DISCONNECT
GROUNDED PLUG FROM ELECTRICAL OUTLET
BEFORE PERFORMING TROUBLESHOOTING
CHECKS.
customer service.
WARNING:
If the supply cord is damaged, it must
be replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a hazard
YEAR
LIMITED
GUARANTEE
3
TOOL GUARANTEE
Minor problems often can be fixed without calling
WARNING:
Before assembling the fan, make sure all parts are
present. Compare parts with contents list. If any part
is missing or damaged, do not attempt to assemble,
install, or operate the product. Contact customer
service for replacement parts. Unplug fan before
assembling any parts to it.
Cleaning:
Before cleaning the fan be sure to
disconnect power cord from the plug. Clean the grill
surface with a clean damp cloth. Do not use harsh
chemical or abrasive cleaners.
Maintenance:
The Internal motor bearings are
Repair:
DO NOT OPERATE THE FAN WITHOUT
THE GRILL IN PLACE. DO NOT USE THE FAN IF IT
HAS MALFUNCTIONED OR BECOME DAMAGED IN
ANY WAY.
Storage:
Keep original carton for storage of the fan.
Coil and tie the power cord to avoid damage during
storage.
permanently lubricated at the factory and do not require
any additional lubrication.
CAUTION:
DO NOT IMMERSE THE FAN OR ANY
WIRES IN WATER. Replace front grill before fan use and
allow fan to dry completely before use. Periodic grill
cleaning with a vacuum will prevent dust build up. The
motor is sealed and does not require any interior
maintenance, cleaning or lubrication.
WARNING:
WARNING:
1 2 3
4 5 6
7 8 9
• Put the and on the , then insert the
in the holes on , then tighten up.
• Insert the through the holes on and , and
secure with .
2
2
7 8 6
9
3 4 1
Handle screw Rear handle
Handle base Drum Frame
Foot pad screw Foot pad Screw nut
Front handle
1
2
3
5
6
9
7
8
4