8
English
S
FIG. 9
T
2. Line up filter threads (T) to vacuum head threads and using
moderate force, turn filter clockwise until tight.
NOTE:
Use care to not damage filter material.
3. Place the vacuum head (C) onto the container and secure it by
closing the canister latches (D).
Cleaning
WARNING:
Blow dirt and dust out of all air vents with dry air at
least once a week. Wear proper ANSI Z87.1 (CAN/CSA Z94.3) eye
protection and proper NIOSH/OSHA/MSHA respiratory protection
when performing this.
WARNING:
Never use solvents or other harsh chemicals for
cleaning the non-metallic parts of the tool. These chemicals may
weaken the plastic materials used in these parts. Use a cloth
dampened only with water and mild soap. Never let any liquid get
inside the motor.
Storage (Fig. 1)
1. Empty the canister, refer to
To Empty Canister
under
Operation
.
2. Clean the vacuum inside and outside.
3. Clean or replace filters, refer to
Filters
.
4. Store the suction hose and the power cord as shown in the
illustration. Secure hose with the hose strap (K) on the back
of the vacuum. Place the unit in a dry room and secure it from
unauthorized use.
Accessories
WARNING:
Since accessories, other than those offered by
D
E
WALT, have not been tested with this product, use of such
accessories with this tool could be hazardous. To reduce the risk
of injury, only D
E
WALT recommended accessories should be used
with this product.
Recommended accessories for use with your tool are available
at extra cost from your local dealer or authorized service center.
If you need assistance in locating any accessory, please contact
D
E
WALT Industrial Tool Co., 701 East Joppa Road, Baltimore, MD
21286, call 1-800-4-D
E
WALT (1-800-433-9258) or visit our website
www.dewalt.com.
OPTIONAL ACCESSORIES
DWV9330
HEPA filter: Captures 99.97% of all
particles greater than or equal to 0.3
microns. Required when picking up lead
paint debris.
DWE46100
5"–6" (127–152 mm)
Cutting/tuckpointing shroud
DWE46101
5"–6" (127–152 mm)
Cutting/tuckpointing shroud kit
DWE46150
5" (127 mm) Cutting/tuckpointing
shroud
Summary of Contents for DWV010
Page 2: ......
