DeWalt DW976, Instruction Manual

Page: 25 / 100

Always release the variable speed switch
and wait until the motor has come to a
complete standstill before changing the
direction of rotation.
Two gear selector (fig. C)
Your tool is fitted with a two gear selector (3) to vary
the speed/torque ratio.
1 low speed/high torque
(drilling large holes or driving large screws)
2 high speed/low torque
(smaller holes, drilling in wood)
For speed rates, refer to the technical data.
Always push the two gear selector
completely forward or completely back.
Do not change gears at full speed or
during use.
Removing and fitting the chuck (fig. E & F)
• Open the chuck jaws as far as possible.
• Tighten an Allen key (14) into the chuck and
strike it with a hammer as shown in figure E.
• Insert a screwdriver into the chuck and remove
the chuck retaining screw by turning clockwise.
• Tighten an Allen key (14) into the chuck and
strike it with a hammer as shown in figure F.
This will loosen the chuck so that it can be
unscrewed by hand.
• To refit the chuck, proceed in reverse order.
Instructions for use
• Always observe the safety instructions
and applicable regulations.
• Be aware of the location of pipework and
wiring.
• Apply only a gentle pressure to the tool.
Excessive force does not speed up
drilling but decreases tool performance
and may shorten tool life.
Prior to operation:
• Insert the appropriate bit.
• Mark the spot where the hole is to be drilled.
• Make sure your battery pack is (fully) charged.
• Select forward or reverse rotation.
Switching on and off (fig. A)
• To run the tool, press the variable speed switch (1).
The pressure exerted on the variable speed switch
determines the tool speed.
• To stop the tool, release the variable speed
switch (1).
• To lock the tool in OFF-position, move the
forward/reverse slider (2) to the central position.
Screwdriving (fig. C & D)
• Select forward or reverse rotation using the
slider (2).
• Use the low speed/high torque position
(1st gear) (3).
• Set the torque adjustment collar (4). The higher
the number on the collar, the higher the torque
and the larger the fastener which can be driven.
Hammerdrilling (fig. C)
• Select the hammer mode.
• Press the variable speed switch (1).
• To stop the tool, release the switch.
Drilling (fig. C)
• Select the drilling mode.
• Proceed as described for hammerdrilling.
Consult your dealer for further information on the
appropriate accessories.
Maintenance
Your D
E
WALT Power Tool has been designed to
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
Lubrication
Your power tool requires no additional lubrication.
Cleaning
• Unplug the charger before cleaning the housing
with a soft cloth.
• Remove the battery pack before cleaning your
Power Tool.
E N G L I S H
21 en - 6