Miter Saw Stand with Folding Legs DW723
This stand is designed for use with most miter saws. If you have any
problem with alignment or mounting, call 1-800-4-D
E
WALT.
CAUTION:
Read and understand all safety instructions in your
miter saw instruction manual before using this or any other accessory
with a miter saw.
Tools Required
1. Socket or wrench set.
2. Drill with 7/16” drill bit. (Not required for D
E
WALT Miter Saws)
General Safety Instructions for Miter
Saw Accessories
•
Open folding legs fully before placing tool on the stand.
•
Safety glasses should be worn when using a miter saw.
•
This miter saw stand is designed to support 500 lbs. (227 kg.)
safely in a work environment. It is unsafe to climb, sit, or stand on
the stand.
•
Follow the mounting instructions carefully. Fasten the tool to the
saw mounting brackets securely as instructed.
•
Do not modify or use the stand for any operation for which it is not
intended.
•
This stand is designed to be used on a flat stable surface. To use
it on an uneven surface is dangerous.
PREPARATION
Lay the miter saw stand on the floor with the fold-
ed legs on top. Push the locking pin and pull
each leg up until the locking pin (A) clicks into its
detent. Lift the stand by the center beam and
place it in an upright position. The stand should
be stable and should not rock. Check the legs to
be sure that the locking pins have engaged and
the legs are firmly held in place.
ASSEMBLY
Work Stop/Support
a. The work stop/support has a clamp (B) to capture the beam and
keep it from being knocked off the beam by your material. The
lever may be locked by turning clockwise and the work stop/sup-
port is free to be repositioned when the lever is turned counter-
clockwise. Do not overtighten, firm pressure on the lever will hold
the stop in place.
b. Adjust the height of the work stop/support by loosening the knobs
on both sides (C) and raise or lower the top surface to align with a
straight edge or level to the saw table. Tighten the bolts
c. The work stop/support (D) can also be installed in the end cap (E)
at the end of the extension arms.
d. The length stop (F) may be rotated up to serve as a length stop or
hold the end of long work pieces.
1
English
A
B
D
C
D
E
F