DeWalt DW060, User Manual

Page: 44 / 104

44
E N G L I S H
Floor set-up (fig. D1 & D2)
• Place the tool on a relatively smooth and level surface.
Wall set-up (fig. D3)
• Hold the tool with both hands against a relatively smooth and level surface.
Aligning the laser beams
The laser beams can be aligned with the walls or at an offset from them.
• Align the laser line of either one of the laser beams with the position
mark or reference point. Move the tool as required.
Instructions for use
Always observe the safety instructions and applicable
regulations.
• Always mark the centre of the laser beams.
• Extreme temperature changes cause movement of internal parts that
may affect the accuracy of the tool. Regularly check the accuracy while
using the tool under these circumstances.
• If the tool has been dropped or has tipped over, check whether there is
damage by performing the field calibration checks. See “Maintenance”.
Prior to operation:
• Carry out the field calibration checks to confirm its accuracy.
• Make sure the tool has been set up securely.
Switching on and off (fig. A)
• To switch the tool on, press the on/off switch (1).
• To switch the tool off, press the on/off switch (1) again.