11
English
2. Grasp the black sleeve of the chuck (D) with one hand and use
the other hand to secure the tool as shown in Figure 6. Rotate the
sleeve counterclockwise (as viewed from the front) far enough to
accept the desired accessory.
3. Insert the accessory about 3/4" (19 mm) into the chuck and
tighten securely by rotating the chuck sleeve clockwise with one
hand while holding the tool with the other hand. Continue to rotate
the chuck sleeve until several ratchet clicks are heard to ensure full
gripping power.
Be sure to tighten chuck with one hand on the chuck sleeve and one
hand holding the tool for maximum tightness.
To release the accessory, repeat Steps 1 and 2 above.
D
FIG. 6
FIG. 7
FIG. 8
Belt Hook and Bit Clip (Optional
Accessories) (Fig. 2)
WARNING: To reduce the risk of serious personal injury,
turn tool off and disconnect battery pack before making any
adjustments or removing/installing attachments or accessories.
WARNING: To reduce the risk of serious personal injury, DO
NOT
suspend tool overhead or suspend objects from the belt hook.
ONLY
hang tool’s belt hook from a work belt.
Torque Adjustment Collar (Fig. 3–5)
Your tool has an adjustable torque screwdriver mechanism for driving
and removing a wide array of fastener shapes and sizes. Circling the
torque adjustment collar (E) are numbers. These numbers are used to
set the clutch to deliver a torque range. The higher the number on the
collar, the higher the torque and the larger the fastener which can be
driven. To select any of the numbers, rotate until the desired number
aligns with the arrow.
Three-Speed Gearing (Fig. 3–5)
The three-speed feature of your tool allows you to shift gears for greater
versatility. To select speed 1 (highest torque setting), turn the tool off and
permit it to stop. Slide the gear shifter (G) all the way forward. Speed
2 (middle torque and speed setting) is in the middle position. Speed 3
(highest speed setting) is to the rear.
NOTE:
Do not change gears when the tool is running. Always allow
the drill to come to a complete stop before changing gears. If you have
trouble changing gears, make sure that the gear shifter is engaged in
one of the three speed settings.
Keyless Single Sleeve Chuck (Fig. 6–8)
WARNING:
Do not attempt to tighten drill bits (or any other
accessory) by gripping the front part of the chuck and turning the
tool on. Damage to the chuck and personal injury may result. Always
lock off trigger switch and disconnect tool from power source when
changing acces sories.
WARNING:
Always ensure the bit is secure before starting the
tool. A loose bit may eject from tool causing possible personal injury.
Your tool features a keyless chuck with one rotating sleeve for one-
handed operation of the chuck. To insert a drill bit or other accessory,
follow these steps.
1. Turn tool off and disconnect tool from power source.
Summary of Contents for DCD985M2
Page 2: ......
