DeWalt DCD730-XE, Instruction Manual

Page: 3 / 16

1
Definitions: Safety Guidelines
The definitions below describe the level of severity for each signal
word. Please read the manual and pay attention to these symbols.
DANGER: Indicates an imminently hazardous situation which, if not
avoided, will result in death or serious injury .
WARNING: Indicates a potentially hazardous situation which, if not
avoided, could result in death or serious injury .
CAUTION: Indicates a potentially hazardous situation which, if not
avoided, may result in minor or moderate injury .
NOTICE: Indicates a practice not related to personal injury which, if
not avoided, may result in property damage.
IF YOU HAVE ANY QUESTIONS OR COMMENTS ABOUT THIS OR ANY D
E
WALT TOOL,
CALL US AT: 1800 338 002 (Aust) or 0800 339 258 (NZ).
Technical Data
DCD790-XE DCD795-XE
Voltage V
DC
18 18
Battery Type Li-Ion Li-Ion
No-load speed
1st
gear min
-1
0–600 0–600
2nd gear min
-1
0–2000 0–2000
Impact rate
1st
gear min
-1
– 0–10 200
2nd gear min
-1
– 0–34 000
Max. torque (hard/soft) Nm 60/23 60/23
Chuck capacity mm 1.0–13.0 1.0–13.0
Maximum drilling capacity
Wood
mm 38 38
Metal mm 13 13
Masonry mm – 13
Weight (without battery pack) kg 1.20 1.24
L
PA
(sound pressure) dB(A) 76 90
K
PA
(sound pressure uncertainty) dB(A) 3 3
L
WA
(sound power) dB(A) 87 101
K
WA
(sound power uncertainty) dB(A) 3 3
Vibration total values (triax vector sum) determined according to EN 60745:
Vibration emission value a
h
Drilling into metal
a
h,D
= m/s² 2.8 3.3
Uncertainty K = m/s² 1.5 1.5
Vibration emission value a
h
Drilling into concrete
a
h,ID
= m/s² – 23
Uncertainty K = m/s² – 1.5
Vibration emission value a
h
Screwdriving
a
h
= m/s² <2.5 <2.6
Uncertainty K = m/s² 1.5 1.5
The vibration emission level given in this information sheet has been measured in
accordance with a standardised test given in EN 60745 and may be used to compare
one tool with another. It may be used for a preliminary assessment of exposure.
WARNING: The declared vibration emission level represents the main applications
of the tool. However if the tool is used for different applications, with different