DeWalt DC305, Original Instructions Manual

Page: 36 / 160

34
E N G L I S H
WARNING: No connection is to be made
to the earth terminal.
Follow the fitting instructions supplied with good
quality plugs. Recommended fuse: 3 A.
Using an Extension Cable
An extension cord should not be used unless
absolutely necessary. Use an approved extension
cable suitable for the power input of your charger
(see technical data). The minimum conductor size is 1
mm
2
; the maximum length is 30 m.
When using a cable reel, always unwind the cable
completely.
ASSEMBLY AND ADJUSTMENT
WARNING:
Prior to assembly and
adjustment, always remove the battery
pack.
WARNING:
Always switch off the tool
before inserting or removing the battery
pack.
WARNING:
Use only D
E
WALT battery
packs and chargers.
Fitting and Removing the Battery Pack (
fi g. A)
• To fi t the battery pack (5), line it up with the
receptacle on the tool. Slide the battery pack into
the receptacle and push until the battery snaps
into place.
• To remove the battery pack, push the release
button (6) while at the same time pulling the
battery pack out of the receptacle.
Replacing the saw blade (fig. C)
● Move the blade clamp lever (3) up to release
the blade clamping mechanism.
● Insert the saw blade into the holder (11) until it
engages. The blade can be installed with the
teeth pointing down or up, or left or right.
● Move the blade clamp lever (3) down to lock the
blade clamping mechanism.
● To remove the saw blade, proceed in reverse
order.
Saw blades
Material Recommended saw blade
ferrous metal fi ne-toothed
non ferrous metal coarse-toothed
wood coarse-toothed
plastic fi ne-toothed
masonry carbide-tipped
A wide variety of dedicated saw blades is available
as an option.
WARNING:
Always select your saw
blade with great care.
Setting the adjustable saw shoe ( fi g. D)
The saw shoe can be adjusted to limit the depth of
cut and prolong the life of your saw blade.
● Push and hold the release button (12).
● Slide the saw shoe (4) into one of the 3 settings.
● Release the button.
Prior to operation:
• Make sure your battery pack is (fully) charged.
• Make sure the battery pack is properly seated.
• Install the appropriate saw blade.
• Make sure the saw blade rotates in the
direction of the arrow on the blade.
OPERATION
WARNING: To reduce the risk
of serious personal injury, turn
tool off and disconnect tool from
power source before making any
adjustments or removing/installing
attachments or accessories.
Instructions for use
WARNING:
● Always observe the safety instructions
and applicable regulations.
● Ensure the material to be sawn is
secured in place.
● Apply only a gentle pressure to the tool
and do not exert side pressure on the
saw blade. If possible, work with the saw
shoe pressed against the workpiece.
This prevents damage to the blade and
stops the tool from jerking and vibrating.