9
English
4. Screw the outer flange (M) onto the spindle (J) (fig. 3B):
–
the ring on the flange (M) must face towards the disc when
fitting a grinding disc (K);
–
the ring on the flange (M) must face away from the disc when
fitting a cutting disc.
5. Press the spindle lock (B) and rotate the spindle (J) until it locks
in position.
6. Tighten the flange (M) with the two-pin spanner supplied.
7. Release the spindle lock.
8. To remove the disc, loosen the flange (M) with the two-pin
spanner.
WARNING:
Do not use a damaged disc.
Fitting a Wire Cup Brush
Screw the wire cup brush directly onto the spindle without using the
spacer and threaded flange.
J
L
O
FIG. 4
N
Mounting and Removing the Rubber
Backing Pad (Fig. 4)
The rubber backing pad is available as an option.
1. Remove the guard from the tool.
4. Securely tighten the screw (H).
5. To remove the guard, slacken the screw.
FIG. 3A
FIG. 3B
M
L
K
I
J
A
B
J
M
K
I
J
M
K
I
Fitting and Removing a Grinding or
Cutting Disc (Fig. 3A, 3B)
1. Place the tool on a table, guard up.
2. Fit the inner flange (I) correctly onto the spindle (J) (fig. 3A).
3. Place the disc (K) on the flange (I). When fitting a disc with a
raised center, make sure that the raised center (L) is facing the
flange (I).
