31 Configuration
devolo Magic 2 LAN
1-1
ted by corresponding flashing behaviour regard-
less of this setting.
Powersaving
If
Powersave
mode has been enabled, the
devolo Magic 2 LAN
1-1
switches to Powersave
mode automatically whenever reduced data trans-
mission over ethernet is detected.
The latency (time for transmitting a data
packet) may be negatively affected.
Powersave mode is disabled in the
devolo Magic 2 LAN
1-1
factory default settings.
Standby
If
Standby
mode is enabled, the
devolo Magic 2 LAN
1-1
automatically switches to
Standby mode if no ethernet connection has been
enabled, i.e. if no network device (e.g. computer) is
switched on and connected to the network inter-
face and if Wi-Fi is disabled.
In this mode, the devolo Magic 2 LAN
1-1
is not
accessible over the Powerline network. As soon as
the network device (e.g. computer) connected to
the network interface is switched on again, your
adapter can also be accessed over the electrical
wiring again.
Standby mode is enabled in the
devolo Magic 2 LAN
1-1
factory default condition.
For information on the LED behaviour of the
devolo Magic adapter in standby mode, re-
.
Firmware update
The currently installed firmware of the
devolo Magic adapter is displayed on the
overview page (see
).
Summary of Contents for Magic 1 LAN1-1
Page 1: ...Manual devolo Magic 2 LAN1 1...
Page 2: ...devolo Magic 2 LAN1 1...
