Initial use
|
|
devolo dLAN TV Sat PC
|
24
The yellow LED for the LAN connection (tuner) is not illuminated.
For connection via dLAN: Check whether the Ethernet cable of the power
supply is plugged tightly into the tuner of the dLAN TV Sat Tuner.
For connection to a switch or dLAN adapter: Check whether you are using a
directly connected Ethernet cable.
For direct connection to a computer: Check whether you are using an Ether-
net crossover cable.
The green LED for the LAN connection (tuner) and the Ethernet LED
on the power supply are not illuminated.
The LEDs flash only when data are being sent to or from the dLAN TV Sat
Tuner.
Check whether the dLAN TV Sat Tuner is reachable via the network.
For a network via dLAN: Ensure that both the dLAN TV Sat Tuner and the
dLAN adapter connected to it are using the same dLAN password.
The dLAN LED (power supply) is not illuminated.
No dLAN connection exists.
If the Power LED is also illuminated in orange: The power supply is in
Standby mode, for example because the dLAN TV Sat Tuner is not con-
nected.
The red Connect LED on the tuner is not illuminated.
The Connect LED is illuminated only if the TV and radio software has been
started on exactly one computer in the network. After you exit the program,
the light goes out.
It is possible that the dLAN TV Sat Tuner is already being used by another
computer in the network. You can only use the adapter with one computer
at a time.
Check whether the driver software is installed on the computer.
Check whether a firewall (on the local computer or on the network) is block-
ing a connection to the dLAN TV Sat Tuner.
Summary of Contents for dLAN TV Sat PC
Page 1: ...dLAN TV Sat PC...
Page 10: ...Introduction devolo dLAN TV Sat PC 10...
Page 60: ...CyberLink TV Enhance devolo dLAN TV Sat PC 60...
Page 75: ...75 devolo dLAN TV Sat PC...