Devolo dLAN pro 1200+ PoE, Manual

Page: 20 / 33

Initial use 19
devolo dLAN pro 1200+ PoE
Check whether the device is connected to the
mains supply correctly and whether the encryp-
tion process has been carried out successfully.
For more information about this, refer to
3.4
Connecting the dLAN pro 1200+ PoE
.
쎲
The LED lights up white if the
dLAN pro 1200+ PoE is ready to operate and a
dLAN connection exists.
쎲
The LED flashes white quickly at regular inter-
vals if the encryption process ( pairing ) is being
performed in the dLAN pro network.
쎲
The LED flashes white at irregular intervals if
the dLAN pro 1200+ PoE is in PowerSave
mode .
쎲
The LED flashes red at regular intervals if the
transmission rate of the dLAN pro 1200+ PoE is
not in the optimum range. For information on
improving the transmission rate, refer to Chapter
5.1 Bandwidth optimization .
The function of the LED status display
can be disabled in
dLAN AVpro manager.
3.3.2 PoE button
This button controls the PoE functionality as
follows:
By default
, PoE functionality of the
dLAN pro 1200+ PoE is enabled .
You can disable the PoE functionality of the
dLAN pro 1200+ PoE
for 10 seconds to briefly dis-
connect the connected device from the mains supply
and restart it.
For more information on PoE functionality, re-
fer to Chapter
2.3.4 PoE operation
.
Indicator light
The indicator light (LED) shows the status of PoE by il-
luminating and/or flashing in different ways:
쎲
The LED lights up white when PoE is enabled.
쎲
The LED is off during the 10-second deactivation
of PoE.
3.3.3 Reset button
The Reset button (next to the Ethernet jack) has the
following function:
쎲
To change the configuration of the
dLAN pro 1200+ PoE back to the
factory
defaults , press the Reset button for more than
10 seconds . Keep in mind that all settings that
have already been configured will be lost!