|
Connection and Startup
11
|
devolo dLAN 200 AVpro i
|
If no device that is switched on (e.g. computer) is connected to the Ethernet port,
the dLAN 200 AVpro i switches to Power Save mode after about 20 minutes
(Power LED flashes). In Power Save mode, the dLAN 200 AVpro i cannot be
accessed via the power supply grid or the coaxial network. As soon as the device
that is connected to the Ethernet port is switched on again, your
dLAN 200 AVpro i is available again via the power supply grid or the coaxial
network.
ETH
This is the connection point on the dLAN 200 AVpro i for con-
necting it to a computer or another network device with the
network cable (included).
The Auto-MDI(X) interface in the dLAN 200 AVpro i automati-
cally detects when a contact is seized and determines the trans-
mission rate of the connected network device.
Coax
Here you connect the dLAN 200 AVpro i to the coaxial connec-
tor using the coaxial cable supplied.
Coax/Hybrid
The switch must have been set to
"Hybrid"
to allow transmis-
sion across the
power supply grid
.
The switch must have been set to
"Coax"
to allow transmission
across the
coaxial network
.
AC
Here you connect the dLAN 200 AVpro i to the power supply
using the power cable (included).
Summary of Contents for dLAN 200 AVpro i
Page 1: ...dLAN 200 AVpro i...
