EN - 5
SE-DV6WM-1
SET UP & OPERATION - DV6x Series CPAP
Initial Set Up of Your Wireless Modem
NOTE: Fully charge battery before beginning set up. Refer to Charging
the Modem Battery.
2. Press Test Call button on Wireless
Modem
a. All LEDS will illuminate for
approximately 1 second, then
turn OFF
b. Battery LED shows battery
status
c. Bluetooth LED will begin flashing
slowly while searching for CPAP
3. Pair with DV6x Series CPAP
a. Modem bluetooth LED will begin
flashing fast when ready to pair
with CPAP (approximately 30
seconds for fast flash to begin)
b. The wireless modem serial
number will appear on the list
when the CPAP finds it
NOTE: Wait until Modem appears
in list, this may take 30 seconds.
DV6WM 122 Rev C
DV6WM 122 Rev C
PRESS
DV6WM 122 Rev C
DV6WM 122 Rev C
4. The Cell Phone LED on
the modem will flash and
then turn solid for a few
minutes
1. Check DV6X CPAP to ensure
Bluetooth is ON
a. Navigate to ADD-ONS
b. Select Bluetooth
c. Press to toggle from OFF to ON
if necessary
c. At Click Item to Pair
screen, select
Wireless Modem
serial number and
press, the menu will
show “Pairing…” then
“Success”
d. The Bluetooth LED on
the Wireless Modem
will stop flashing and
stay ON while reading
data from the CPAP
PRESS
DV6WM 122 Rev C
5. Find a location where Cell
Phone LED is ON (not
flashing) and place the
modem where it will not
be disturbed
NOTE: Bluetooth and Cell
Phone LEDs will normally be
OFF; they will be active only
when modem is talking to
CPAP or to the server; you
may not see this happen.
Leave modem alone.
6. After call sequence is
finished, all LEDs will turn
OFF
DV6WM 122 Rev C
PRESS
