9 - ENG
A16064
NOTE:
Nozzles are color coded
to match colored nozzles on
panel.
7.
Place the nozzle holder onto
the panel (located on the handle
assembly) and push each nozzle
holder into place.
NOTE:
The pump on this unit is
maintenance free and requires no oil,
If there is a problem with the pump
contact an Authorized Service Center.
Risk of bursting.
Use a tire pressure
gauge to check the tires pressure
before each use and while inflating
tires; see the tire sidewall for the
correct tire pressure.
NOTE:
Air tanks, compressors and similar
equipment used to inflate tires can fill
small tires similar to these very rapidly.
Adjust pressure regulator on air supply
to no more than the rating of the tire
pressure. Add air in small increments
and frequently use the tire gauge to
prevent over inflation.
OPERATING INSTRUCTIONS
BASIC ELEMENTS OF A
PRESSURE WASHER
High Pressure Pump (located inside
the shroud)
: Increases the pressure
of the water supply.
Engine:
Drives the high pressure
pump.
High Pressure Hose:
Carries the
pressurized water from the pump to
the gun and spray wand.
Compare the illustrations with your unit to familiarize yourself with the location
of various controls and adjustments. Save this manual for future reference.
High
Pressure
Hose
Spray
Gun
Quick-Connect
Spray Wand
High Pressure Pump
(located inside the shroud)
Engine
Spray Gun:
Connects with spray
wand to control water flow rate,
direction, and pressure.
Quick-connect spray wand:
Allows
the user to quickly change out high-
pressure nozzles. Refer to Spray Wand
Nozzles.
Chemical Hose (not shown):
Feeds
cleaning agents into the pump to
mix with the water. See How To
Apply Chemicals/Cleaning Solvents
instructions in this section.
Summary of Contents for A16064
Page 56: ...A16064...
