CUTTER SPINDLE BELTS: Fig.3
1:
Uncouple seat switch wire (bullet connector at rear of seat)
2:
Remove seat panel
3:
Remove belt guide from rear of pulley
4:
Loosen nut "B" and remove main drive belt
5:
Remove covers over cutter spindles
6:
Position clutch laver in engaged position
7:
Remove four "R" clips
8:
Remove clutch bars
9:
Loosen nuts on brake and turn plate sideway ⅛ turn to allow clearance for belts to slip through.
(Do not loosen ⅝ nuts)
10:
Replace belts and reassemble.
CLUTCH ADJUSTMENT: Fig.3
1:
Loosen nut ”E”.
2:
Tighten nut underneath square block (1/2 turn should be sufficient).
DO NOT OVER ADJUST, clutch should have .75mm gap between clutch lining and pulley surface
when in brake position.
3:
Ensure nut “E” tight when adjusted.
LUBRICATION CHART:
Engine
As per engine manual
Grease king pins
20 hours
Grease front axle pivot, fig.4
20 hours
Grease vertical gear steering gear shaft, fig.4
20 hours
Grease cutter spindles & clutch spindle, fig.5
20 hours
Oil steering wheel shaft (top & bottom), fig. 4
20 hours (oil)
Grease steering gears, fig.4
20 hours (smear with grease)
Oil all moving parts
20 hours
6
GREASE
Fig.4
OIL
GREASE
Fig.5
