Dethleffs 2006 Globetrotter XXL, Instruction Manual

Page: 93 / 166

93
Globetrotter XXL - 11-06 - DET-0047-01
EN
Appliances
10
Selecting gas and 240 V
electrical operation:
Select gas operation and 240 V electrical operation on the operating unit.
When the heater is turned on, it starts with the last set operating mode.
Switching on the heater: Press the " " button (Fig. 65,4). The "Off" symbol (Fig. 66,2) flashes.
Press the "+/On" button (Fig. 65,3). The "On" symbol (Fig. 66,1) flashes.
The heater starts automatically.
Press the " " button (Fig. 65,2). The operation ends, the display moves to
home position and the "On" symbol lights up.
Switching the heater off: Press the " " button (Fig. 65,4). The "On" symbol (Fig. 66,1) flashes.
Press the "-/Off" button (Fig. 65,5). The "Off" symbol (Fig. 66,2) flashes.
The heater is turned off.
Press the " " button (Fig. 65,2). The operation ends, the display moves to
home position and the "Off" symbol lights up.
10.2.1 Setting the rotational speed of the circulating pump
The rotational speed of the circulating pump can be set with the sliding switch
(Fig. 67,2). At a lower rotary speed, the operating sounds of the pump are qui-
eter.
The sliding regulator is located in the hot-water heater area.
Setting the output: Push sliding trap (Fig. 67,1) towards the right. The output is reduced.
Push sliding trap towards the left. The output is increased.
If gas and 240 V electrical operation is selected and if the vehicle is con-
nected to the 240 V power supply, then the hot-water heater at first only
operates in 240 V electric operation. Only if the heat output is insufficient
does the gas operation also automatically switch on.
The gas operation is only possible when the regulator tap on the gas bottle
and the "Heater/boiler" gas isolator tap are opened.
240 V electrical operation is only possible when the vehicle is connected to
the 240 V power supply.
The hot-water heater is equipped with a very powerful pump. In smaller
vehicles, the pump can only be operated at full power if the pipes are bled.
Otherwise, this will increase wear; loud operating noises are the result.
Fig. 67 Rotational speed reduction
switch