SHOWN FOR REFERENCE
OUTSIDE ECL-620
TEMPLATE
TRIM
INSIDE ECL-620 TEMPLATE
LEFT HAND REVERSE BEVEL DOOR
(SWING OUT)
Fig. 4
Fig. 5
Preparing the Door & Frame
3. Orient the
INSIDE
template TPL-620 for proper door handing
and tape to door per Fig 4. See Fig 5 for hole locations.
4. Refer to Drill & Tap Schedule A (page 2):
a. Mark, center punch and drill six (6) holes marked "C" on
the door.
b. Mark, center punch, drill and tap the two (2) outer holes
of the strike, marked "A" on the frame.
c. Mark, center punch, drill and tap the two (2)* outer holes
of the keeper, marked "B" on the frame.
*DO NOT MARK OR DRILL CENTER HOLES MARKED
"B" ON KEEPER AND STRIKE AT THIS TIME.
d. Mark and center punch then drill with pilot drill bit, the holes
marked "D/E", "F" and "G".
CRITICAL TO DRILL STRAIGHT AND LEVEL AS POSSIBLE.
"E" HOLES LOCATE THE TRIM.
FIRE RATED pair of doors with mullion:
e. Strike hook is required. Mark, center punch, drill and tap
the two (2) holes marked "H" on the door.
5. Drill 1/2" holes marked "E" and "F"
halfway
through door
from inside to outside.
6. Remove Inside Template TPL-620 from face of door
and discard.
PREPARING ECL-600 BACKPLATE FOR THE ECL-620 - Fig 7
7. Install the input lever cam onto the backplate with the push
nut, using disposable tube as shown. Discard the tube after use.
PREPARING THE OUTSIDE OF DOOR - Fig. 8
8. Place
OUTSIDE
template (TPL-620), align 4 holes marked "E"
with pilot holes "D" and secure with tape.
9.
Ensure proper handing before proceeding.
10. Drill 1" hole marked "G" through door.
11. Mark, center punch and drill 1-1/2" hole marked "J" at least
1-1/8" deep from
OUTSIDE
to inside, but do not drill through.
12. Locate 4 existing pilot holes marked "E" and drill Ø1/2" hole through door.
13. Remove
OUTSIDE
template TPL-620 and discard.
Fig. 8
Fig. 7
LHRB SHOWN
INS-620/PM Page 4