7
Installation Guide
M100-AT4 Interface Card
M100-AT4 Interface Card
The
M100-AT4 Interface Card
is a
plug-in card which allows the
OpenCom 130 to be connected to
analogue trunk lines. The
M100-AT4
Interface Card
has four analogue
ports; the supported dialling mode is
dual-tone multifrequency (DTMF).
Calling Line Identification Presenta-
tion (CLIP) and the transmission of call
charges data (12kHz or 16kHz pulses)
are currently not supported.
Scope of Delivery
■
One M100-AT4 Interface Card
■
One installation manual
Installation
The interface card should be installed
on the OpenCom 130 add-on module.
The interface card should be in-
stalled by qualified personnel only!
For information on installing the
OpenCom 130 modules and the inter-
face cards please also refer to the
“OpenCom 130 Mounting and Commis-
sioning” manual.
Proceed as follows:
DANGER!
Hazardous voltages
inside the device.
1. Switch off the OpenCom 130. Open
the housing cover.
2. Remove the interface card from its
transport packaging. Make sure it
is the correct type of card. There is
a sticker with the type name on the
connector.
CAUTION!
Static charge can
damage electronic components.
Please observe the regulations re-
garding electrostatically sensitive
components.
