Model CXT-IR
CXT-IR Instruction Manual
Rev. 2.1
Page 16 of 48
b)
If the unit utilizes the “C” sized lithium 3.6V batteries and battery holder, install the batteries being
careful to install the batteries properly. Power will be applied, and the unit will proceed to power
up (Section 2.6).
B
la
c
k
Wh
t/
Bl
k
W
h
t/B
rn
Red
To Sensor
24V Power
To External
Ret
ur
n
24V
D
C
Figure 14 Terminal Interconnect for Smart Battery Pack
4.
Replace the junction box cover after Initial Start Up. Ensure that the cover is screwed down completely and
that the Allen Head screw is tightened down to secure the cover in place.
NOTE
: A 6-32 or 8-32 threaded exterior ground point is provided on most junction boxes for an
external ground. If the Sensor Assembly is not mechanically grounded, an external ground strap
must
be used to ensure that the sensor is electrically grounded.
