![Detcon 880A-N1R Operator'S Installation And Instruction Manual Download Page 40](http://html1.mh-extra.com/html/detcon/880a-n1r/880a-n1r_operators-installation-and-instruction-manual_2487578040.webp)
880-N1R
880-N1R Instruction Manual
Rev. 0.0
Page 36 of 38
In this case it is impossible to balance the data bus because there is no distinct beginning or end to the cable
run. The best way to make this type of installation successful is to install repeaters in a few key areas as
shown in Figure 45. Repeaters are used to eliminate the t-taps or stubs, which can cause communication
problems. The location and number of stubs will dictate where repeaters need to be installed. Four repeaters
are installed to eliminate the stubs.
09
08
0a
Control Room
01
02
07
06
0b
04
05
03
Rt
Rt
Rt
Rt
Rt
Rt
Rt
Rt
Rt
Rt
repeater #2
repeater #1
repeater #3
repeater #4
Figure 45
Four repeater Data Bus
Notice there are 5 different data buses that make up the communications network. The first one consists of the
master located in the control room, device 09, repeater #1, device 01, device 02, repeater #2, device 03, and
device 05. Notice the termination resistors at the beginning and end of this bus section. The second bus starts
at repeater #2. It consists of the repeater and device 04. Since this is a new bus, it has terminating resistors at
each end. The third bus starts at repeater #1. It includes device 08, repeater #3, device 07, repeater #4, and
device 06. It also has its own resistors. The fourth bus starts at repeater #3 and consists of the repeater, device
0A, and the terminating resistors. The fifth bus starts at repeater #4 and consists of the repeater, device 0B,
and termination resistors. This configuration isolates all of the t-tap stubs. This configuration should function
properly as long as the wire type and proper distances are observed.
The following chart shows an approximation of wire length vs. data speed. Detcon operates its equipment at
19,200bps (baud) and lower.
Figure 46
wire length vs. data speed
100 mbps
10 mbps
1 mbps
100 kbps
10 kbps
1 kbps
0 ft
10 ft
100 ft
1000 ft
5000 ft
10000 ft
Summary of Contents for 880A-N1R
Page 2: ...880 N1R 880 N1R Instruction Manual ii Page intentionally blank...
Page 43: ......
Page 44: ......
Page 45: ......