TROUBLE SHOOTING
If you are having trouble with your table, try the simple steps outlined below.
If problems persist, please refer to the Series 7/8 or Series 9 Troubleshooting Guide.
POWER-SAVING CONTROL BOX:
•
The Control Box automatically powers down into ‘Standby’ mode after
approximately 10 seconds of inactivity.
•
During ‘Standby’ mode, the Control Box only consumes 0.1 watt of power.
•
With the Control Box in ‘Standby’ mode, the table can lose power without
affecting the synchronization of the Lifting Columns. However, if the Control
Box is still active, and not in ‘Standby’ mode, a power loss will require that the
Lifting Columns be re-synchronized.
•
Power fluctuations and brownouts can also cause the need for re-synchronization.
Note:
The Control Box does not re-set (initialize) by being unplugged and plugged
back in. Refer to the Initialization procedure below.
INITIALIZING THE CONTROL BOX:
•
In the unlikely event that an error occurs, press and hold the
Up
and
Down
arrows
simultaneously for 5 seconds to reset the Control Box.
•
Synchronize the Lifting Columns as outlined below.
SYNCHRONIZING THE LIFTING COLUMNS:
•
Operate the table all the way down to its lowest position, and then release
the
Down
arrow
.
•
Press the
Down
arrow
again, and hold.
•
After a couple of seconds, the table will give a small, visible ‘up-down’ motion,
where the Lifting Columns are finding their correct bottomed-out position.
•
The Lifting Columns are now synchronized via the software in the Control Box.
•
Operate the table all the way up and all the way down to confirm proper function.
PRODUCT SPECIFICATIONS
Range of Adjustment
24.3"-51.7" (S7); 23.8"-49.8" (S8); 22.5"-48.5" (S9)
Glide Adjustment
25/32
"
Distributed Weight Capacity
(includes worksurface weight)
295 lbs. (2-leg)* / 458 lbs. (3-leg)*
Wire Management Included
Yes
Controller
Up/Down, Presets, Digital Presets
Decibel Rating
< 42.5 – 44.1 dBa
Volts
120v AC
Frequency & Phase
60 Hz, Single Phase
Amps
2-leg: 3.4A / 3-leg: 5.0A
Watts
2:leg: 400W / 3-leg: 600W
Standby Power
0.1W
Adjustability Speed
1.7
"
/sec.
Duty Cycle
10%
* Includes weight of worksurface, which weigh ~4.5lbs/ft
2
or ~.031lbs/in
2
.
•
Rectangular tops weigh between 24-68lbs; a 58"x29" top weighs 52lbs.
•
90º tops weigh between 44-98lbs; a 58"x58" (23"d) top weighs 68lbs.
•
120º tops weigh between 60-91lbs; a 52"x52" top weighs 72lbs.
Summary of Contents for Adjustables 7
Page 1: ...USER GUIDE 7 8 9...
