HEIGHT ADJUSTMENT CONTROLLERS
OPERATING THE CONTROLLER
The flush-mount activation has two buttons for user control.
•
Press and hold either the
Raise
or
Lower buttons
to reach the desired height.
•
As a safety feature, the user must continuously hold down the button in order
for the table to move.
Note:
The buttons can be mounted with both the
Raise
and
Lower buttons
visible on the top surface, or it can be wrapped around the worksurface edge for
an intuitive “push down”, “pull up” action.
OPERATING THE CONTROLLER
•
Press and hold either the
Up
or
Down arrow
to reach the desired height.
•
To switch to a stored height in memory press and hold the numbered button
that has the pre-set height stored into memory until it reaches the stored height.
•
As a safety feature, the user must continuously hold down the button in
order for the table to move.
STORE HEIGHT INTO MEMORY
To set into memory the desired height for either seated or standing work,
use the three pre-set buttons.
•
Press either the
Up
or
Down arrow
until the desired height is attained.
•
Press the
S button
once and then your choice of
pre-set buttons 1-3
to set
that
particular height.
•
To pre-set additional heights repeat this sequence using the remaining
1-3 buttons.
Flush-Mount
Activation Buttons
3 Pre-set
Programmable
Summary of Contents for Adjustables 7
Page 1: ...USER GUIDE 7 8 9...
