79 Trenton Avenue, Frenchtown NJ 08825
© Copyright 2018 Designplan Lighting, Inc.
installation instructions
P: 908-996-7710
F:
908-996-7042
5
of
5
STEP OUTSIDE 5.1, 5.2, 6.1, 6.2, 6.3
Wiring Diagram
500
mA
(Static White Series Connection)
DRIVER
The individual lamps must be connected in series.
Only power up the system once all the lamps have been connected.
• LED lights work at constant current. When choosing a power supply unit, you need to consider the current
by which the LEDs are driven and their maximum power consumption.
•
Only power up the system once all the lamps are connected. Connecting an individual lamp to an active
power supply may cause the lamp to break due to over-voltage.
• The electronic power supply is constant current, so to a certain extent it automatically compensates the
voltage drop associated with cable length; however, we advise not exceeding 100 feet.
•
Lamps and power supply units must be installed in well-ventilated boxes or locations to allow a natural
heat diffusion and avoid the devices overheating.
• On the power system, install a surge protection device to reduce the intensity of any voltage spikes to
protect the lighting fixtures from the risk of damage.
• Fixture NOT suitable for covering with thermally insulating material
.
TM
