7
8. ATTACHING THE FAN
BLADES
Caution: Remove 5 rubber packing
mounts and discard before installation.
Step 1 Attach the blade to the blade
bracket using the screws and fiber washers
as shown in Figure 14. Start screw into
bracket. Repeat for the two remaining
screws.
Step 2 Tighten each screw. Make sure the
blade is straight.
Step 3 Fasten blade assembly to motor
using the screws supplied. (Fig. 14)
Figure 14
Figure 15
Screws
Screws
Fiber
washers
Blade bracket
Blade
9. INSTALLING THE
MOUNTING PLATE
1. Remove the 1 of 3 screws from the
mounting ring and loosen the other
2 screws. (Do not remove)
2. Place the key holes on the mounting
plate over the 2 screws previously
loosened from the mounting ring,
turn mounting plate until it locks in
place at the narrow section of the
key holes. Secure by tightening the
2 screws previously loosened and
the one previously removed. (Fig.
15)
Mounting
plate
Mounting ring
Screws
