Drill a hole on floor with
1/2" dia,1"deep , and align
center of bolt in lower box.
Fix the ciamp to connecting
tube in midway.
2"
2 7/16"
13/32"
STEP 1
：
DIRECTIONS FOR CHANGING
HANDING OF DEVICE
Handing of device is preset at factory
for RHR.To change handing of device,
follow steps shown below and see
DRAWING FOR STEP 1.
1.Loosen screws ’A’ and remove screw
‘B’ and spring ‘C’.
2.Reverse the postions of screw ’B’ and
spring ‘C’ and then tighten screw ‘A’.
3.The device is now set for LHR.
STEP 2
：
MARK CENTER LINE ON DOOR
Mark center line on inside of door.
Establish the horizontal center line of
the device by drawing a line across
the door 40” above floor line.
STEP 3
：
MARK DOOR AND DRILL HOLES
1.Fold and apply template (A) to edge of
door and mark door as indicated on
template (A).
2.Drill holes A X 6 in accordance with the
diameters as indicated on template (A)
STEP 7
：
INSTALL BOTTOM LATCH
ASSEMBLY
1.Align vertical center line of bottom
latch assembly and lower connecting tube
as shown on template. Mark door as
indicated on template (B-2).
CAUTTON : BE SURE THE DISTANCE
FROM BOTTOM SIDE OF DOOR EDGE
TO BOTTOM OF BOTTOM LATCH
ASSEMBLY IS 13/32".
2.Tighten screws to install bottom latch
assembly.
STEP 6
：
INSTALL TOP LATCH ASSEMBLY
1.Align vertical center line of top latch
assembly and upper connecting tube as
shown on template (B-1). Mark door as
indicated on template (B-1).
CAUTION: BE SURE THE DISTANCE
FROM DOOR FRAME TO LINE
W MUST BE 2"
2.Tighten screws to install top latch assembly.
STEP 5
：
INSTALL TOP STRIKE
1.Align vertical center line of top strike and
upper connecting tube as shown on template
(B-1).Mark door as indicated on template
(B-1).
2.Tighten screws to install top strike with
proper adjustment.
STEP 4
：
INSTALL DEVICE BODY
1.Remove the head cover from the device
body and end cover from the mounting
bracket by removing the screws that hold
them on.
2.Align tailpiece receiver of exit device and
trim/cylinder tailpiece, so it slides onto
trim/cylinder tailpiece. Also align screw
holes on exit device head with mounting
holes on the door.
3.Install and tighten the mounting screws
for the head of the exit device and end
cover mounting bracket.
