T
O
P
STRIKE
HEAD
ASSEMBLY
TOP LATCH
ASSEMBLY
BOTTOM LATCH
ASSEMBLY
TOP LATCH
BASE
TOP LATCH COVER
ROD GUIDE
TOP ROD
THRU
BOLTS x10
ROD GUIDE
INSERT
BOTTOM
ROD
ROD GUIDE
INSERT
BOLT
CONNECTOR
ROD
CONNECTOR
ROD
ROD GUIDE
BOT TOM
LATCH
BASE
FLOOR STRIKE
BOT TOM
LATCH COVER
HEAD COVER
END COVER
Install rod guides onto top
and bottom rods at the
midway point
Drill a 5/8" dia. hole in
he floor 1" deep,
and align with center
of bolt in bottom latch
assembly
STEP 1
：
DIRECTIONS FOR CHANGING
HANDING OF DEVICE
Handing of device is preset at factory
for RHR.To change handing of device,
follow steps shown below and see
DRAWING FOR STEP 1.
1.Loosen screws ’A’ and remove screw
‘B’ and spring ‘C’.
2.Reverse the postions of screw ’B’ and
spring ‘C’ and then tighten screw ‘A’.
3.The device is now set for LHR.
STEP 5
：
INSTALL TOP STRIKE
1.Align vertical center line of top strike and
upper connecting tube as shown on template
(B-1).Mark door as indicated on template
(B-1).
2.Tighten screws to install top strike with
proper adjustment.
STEP 2
：
MARK CENTER LINE ON DOOR
Mark center line on inside of door.
Establish the horizontal center line of
the device by drawing a line across
the door 40” above floor line.
STEP 3
：
MARK DOOR AND DRILL HOLES
1.Fold and apply template (A) to edge of
door and mark door as indicated on
template (A).
2.Drill holes A X 6 in accordance with the
diameters as indicated on template (A)
STEP 4
：
INSTALL DEVICE BODY
1.Remove the head cover from the device
body and end cover from the mounting
bracket by removing the screws that hold
them on.
2.Align tailpiece receiver of exit device and
trim/cylinder tailpiece, so it slides onto
trim/cylinder tailpiece. Also align screw
holes on exit device head with mounting
holes on the door.
3.Install and tighten the mounting screws
for the head of the exit device and end
cover mounting bracket.
