www.fmiproducts.com
114370-02H
12
OPERATION
Continued
TO TURN OFF GAS
TO APPLIANCE
1. Turn control knob clockwise
to
the OFF position.
2a. Set selector switch in the OFF position.
2b.
If Using Optional Hand-Held Remote:
Set
selector switch in the OFF position to
prevent draining battery.
3. Close equipment shutoff valve (see Figure
8, page 9).
Figure 12 - Correct Burner Flame Pattern
Figure 13 - Incorrect Burner Flame
Pattern
Yellow
Tipping
INSPECTING BURNERS
BURNER FLAME PATTERN
Check flame pattern often. Figure 12 shows
correct burner flame pattern.
NOTICE: Do not mistake orange
flames with yellow tipping. Dirt
or other fine particles are burned
by appliance, causing brief
patches of orange flame.
If burner flame pattern is incorrect, as shown
in Figure 13
• turn appliance off (see
To Turn Off Gas
to Appliance
, page 12
• see
Troubleshooting
, page 13
MANUAL LIGHTING
PROCEDURE
1. Follow steps 1 through 6 under
Lighting
Instructions
, page 10.
2. Depress control knob and light pilot with
match.
3. Keep control knob pressed in for 30 sec
-
onds after lighting pilot. After 30 seconds,
release control knob. Now follow steps 9
through 11 under
Lighting Instructions,
page 10.
CLEANING AND
MAINTENANCE
WARNING: Turn off heater
and let cool before cleaning.
CAUTION: You must keep
control areas, burner and cir
-
culating air passageways of
fireplace clean. Inspect these
areas of fireplace before each
use. Have fireplace and chimney
inspected yearly by a qualified
service person. Fireplace may
need more frequent cleaning due
to excessive lint from carpeting,
bedding material, pet hair, etc.
