User Guide for On Hold Appliance OH-4910 Document G/01144 Issue 2 Page 2
MADE IN AUSTRALIA
Instructions
To Record Your Own Message
1.
Connect the message source machine (eg. tape player, sound card etc.) to the
On Hold Messenger Appliance
3.5 mm
TS phone record socket (you can use mono or stereo). The output level from the source should be no more than about
1 (one) Volt peak to peak. If this can not be measured, a couple of trial runs will be necessary to determine the volume
on the source player required to achieve a loud and clear but undistorted recording.
2.
Momentarily press the recessed Record button on the
On Hold Messenger Appliance
with a pen or pencil and the red
Record LED will pulse (please note that the green Play LED also stays on at this time).
3.
Press the play button on the cued source machine within 30 seconds.
4.
The
On Hold Messenger Appliance
will automatically start recording when audio is detected and then stop recording
when you press the Record button again, or when four (or eight) minutes have elapsed.
Playback
1.
Plug the
On Hold Messenger Appliance
into the Phone system MOH port and do a test. Simply call in and ask the
operator to put you on hold. You can adjust the output volume control using a small bladed screwdriver. Turning it
clockwise increases the output.
Please consult the factory if more output volume is required. This is common to
some older Commander
™
and PABX systems. There is an output boost setting inside the On Hold Messenger
box.
Specifications
Enclosure
Injection moulded ABS (
acrylonitrile-butadiene-styrene
).
Dimensions
50 mm x 110 mm x 80 mm.
Operating Temperature Range
-10
→
+70
°
C.
Message Recording /Playback
Input Sample Rate
8 kHz.
Upper pass band
3.4 kHz.
Message retention
100 years.
Record Cycles
100, 000.
Messages length
Up to four minutes (eight minutes optional).
Record Input level
≈
1 V p-p (350 mV RMS).
Output level
≤
4.4 V p-p (adjustable).
Frequency range
500 Hz
→
3.4 kHz.
Power requirement
6 - 12 Vdc 50 mA (600 mW), polarity insensitive
(Power adaptor supplied separately)
Power connector
2.1 mm concentric
MOH connector
RJ12 6P2C socket
Record Input connector
3.5 mm stereo (mixed to mono) TS phone socket
Displays
Playing LED indicator (green), Recording LED (red).
Isolation
Complies to TS001
NZ Telepermit
PTC 212/92/005
ACA Supplier’s Code Number
N468.
Warranty Two
years.
Est. 1968
Telephone: +613 9758 5933
Facsimile: +613 9758 5560
Email:
Web Site:
www.design2000.com.au
